Hi - > I just finished installing the sub receiver in my K3 # 4359. Set up the > filters, sub synth, etc.The subrx book sez (page 44), that if you press & > hold the SUB for 2 seconds or more it will go into Diversity mode. That it > does. It also sez that the kHz dot on VFO A will flash, to indicate Diversity > mode. That it does. But it also sez on page 45 that when this is done, it > sets the sub to the same frequency as the main (VFO A). It does NOT - > frequency in VFO B stays right where it was. I did find a way to make it > work, but I'm wondering if the book is wrong, if I'm not reading it > correctly, or if there is a screw-up in the firmware. I did download the most > recent non-beta f/w into the K3. > > On my K3 I have to first do the A>B twice to get both VFO's on the same freq, > with the same settings, then go into Diversity mode, and finally press the > SUB button again for less than 2 seconds to make it "Link". This keeps it in > Diversity mode and "Links" the two VFO's on the same frequency. If it worked > as the book sez on page 45, it'd be a lot easier. Any suggestions?
Jim / W6JHB ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
