End of first paragraph - should be ohms instead of volts. 73, Don W3FPR ------------------------------------------------ Cecil,
I suggest you check the soldering on the front panel board, be especially aware that on all ICs pin 1 is soldered, that is easy to miss. Check the schematic for the front panel board and look at the symbol for the encoder. Measure to make certain you have 5 volts on the 5 volt pin (measure at the encoder terminal not the board), then turn power off and measure the resistance from the encoder ground terminal and ground - expect zero volts. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html