The MH2 is an electret mic wired with a Foster plug having Elecraft's Kenwood compatible pin assignments. The microHAM DB37-EL-K3R and DB37-EL-K23 cable sets are configured for the Electaft/Kenwood standard and the supplied Foster to RJ-45 adapter cable allows connecting the MH2 to the rear panel MIC jack (RJ45).
Since the MH-2 is an electret mic and requires bias voltage on pin 1, it is necessary to install the "electret" jumper for the RJ-45 jack located just in front of the three trimmers in the center of the MK II circuit board as shown in step 5 of "Preparing microKEYER II for Use" - page 8 of the microKEYER II User Manual. 73, ... Joe Subich, W4TV microHAM America, LLC. http://www.microHAM-USA.com http://groups.yahoo.com/group/microHAM On 2/23/2013 7:25 PM, Ricardo PY2PT wrote:
Dear guys, Please, any friend use the hand mic (MH-2) with a MicrokeyerII interface? Best Regards Ric PY2PT ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html