One other way to prevent the K3 from transmitting (it will still key
but with no RF output). Apply 5v to pin-7 of the ACC after
placing TX INH set to HI in the CONFIG menu. Remove the 5v and the
radio will function normally.
http://www.kl7uw.com/TX-INHIBIT.htm
shows how to use inhibit on VHF bands but not on HF. A simple
modification could be done where the relay is replaced by a toggle
switch and eliminate the transistor and BAND and DIGOUT
circuitry. The voltage regulator, 1K resistor, and diode are not
needed and can be replaced with a 2.2K to 10K resistor (K3 manual,
page 19) connected to 12v thru a toggle switch.
I just boot my computer before powering up the K3 (I am not using the
LP Bridge).
73, Ed - KL7UW
http://www.kl7uw.com
dubus...@gmail.com
"Kits made by KL7UW"
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html