I understand that the K3 is doing the decoding, but does that mean that it must be presented in the VFO B area?
73, Jim N7US -----Original Message----- The P3 SVGA doesn't do CW, RTTY, or PSK31 decoding. The K3 does the decoding and presents it in the VFO B area. A copy is available through the K3 serial port programmers command set, and P3 SVGA uses that TB command. The K3 Utility uses the same K3 decode mechanism for its Terminal page. The heavy lifting for TTY, PSK, and CW decoding is done in K3 firmware. 73 de Dick, K6KR > On Jul 10, 2014, at 8:43, "Jim Leder \(Hotmail\)" <k8...@hotmail.com> wrote: > > Anyone from Elecraft, will the K3/P3/SVGA ever have the ability to decode on the P3/SVGA attached big screen while NOT sending the decoded output to the K3 VFO B area? I know it will decode to the large screen and at the same time send that decoded text to the K3, but it sure would be nice to NOT send the the decode text to the K3 VFO B area. I certainly have NO idea what's involved, but it seems it might be a firmware change. > > I have been debating an SVGA add-on, since I have my K3/P3 and KPA500 pretty much loaded for my needs, but don't see any real benefit to the SVGA card without the above stated ability. > > Seems a few others have also thought this a good idea some time back, but I thought to ask again. Is it on an Elecraft 'to do' list? > > BTW, my K3/P3/KPA500 is the best ham gear I have ever owned and operated in 50+ years of being a ham! Nothing else comes close. And, I have had a LOT of gear! > > 73 ... > Jim Bob Buckeye > AKA > **** Jim Leder**** > K8CXM since 1961 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com