Having problems with install of the KXV3B upgrading from a KXV3A. The pins are two long on the KXV3B, with BNC connectors up as far as they will go in the rear slot? I tried putting the pins in tilting the board with the BNC connectors not out of the slot, it was too much of an angle, they will not go in? I guess I can cut the pins shorter on the KXV3B but wanted to check on that first. Any help would be appreciated. thank you 73 Emory WM3M ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com