The KXV3 boards are a tight fit. I've had mine in and out a few times
(replaced blown pin diodes) and finally figured out that I needed to
file the square cutout in the frame a bit at the top corners in order to
let the BNC jacks clear; I rounded the corners slightly with a needle file.
Also, depress the board you are plugging into; there is a bit of flex
which may give you enough clearance.
73,
Drew
AF2Z
On 06/11/15 15:11, ejk...@gmail.com wrote:
Having problems with install of the KXV3B upgrading from a KXV3A.
The pins are two long on the KXV3B, with BNC connectors up as far as they will
go in the rear slot?
I tried putting the pins in tilting the board with the BNC connectors not out
of the slot, it was too much of an angle, they will not go in?
I guess I can cut the pins shorter on the KXV3B but wanted to check on that
first.
Any help would be appreciated. thank you 73
Emory WM3M
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com