Great point Tom. Thanks.
john

----- Original Message ----- From: "Tom Hammond" <[EMAIL PROTECTED]> To: "n3drk" <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]>; "elecraft" <elecraft@mailman.qth.net>
Sent: Sunday, January 22, 2006 3:30 PM
Subject: Re: [Elecraft] spectrogram


Any time you use an audio-based oscilloscope, monitoring the AF output from your receiver, you have to be aware that whatever you see on-screen is not only representative of the signal itself BUT to a bigger extent it reflects those characteristics placed upon it by the receiver itself (it's filters, the AGC characteristics, etc.). As a result, you should always remind yourself that what you're looking at (if it's coming thru the receiver's audio system) is not necessarily what is actually 'on the air'.

73,

Tom Hammond    N0SS

At 11:55 AM 1/22/2006, n3drk wrote:
Listed below is a link for a Windows based Oscilloscope. This can be used for transmitting but I do not know about receiving. What do you guys think? By the way thanks to all for responding to my original post.

http://www.dxzone.com/cgi-bin/dir/jump2.cgi?ID=3428


73s
john-n3drk


----- Original Message ----- From: <[EMAIL PROTECTED]>
To: "n3drk" <[EMAIL PROTECTED]>; "elecraft" <elecraft@mailman.qth.net>
Sent: Sunday, January 22, 2006 9:31 AM
Subject: Re: [Elecraft] spectrogram



John,

Sjpectrogram is a FFT (Fast Fourier Transform) spectrum analyzer program. It's display is amplitude versus frequency. What you need to display the "Christmas Tree" and CW waveforms is an oscilloscope display. In the case of the Christmas Tree, the oscilloscope is set up to display RF drive or audio on the horizontal axis and RF output on the vertical axis (the oscilloscope is in X-Y mode, with x=drive, Y=RF out). For the cw envelope you use the oscilloscope in the conventional mode where the horizontal axis is time and the vertical axis is voltage. So the short answer to your question is "NO".

jim, AB4CZ

can Spectrogram also show the
Christmas Tree effect for SSB? How about the rise and fall of the CW note? What about in receive mode. Can it also show these for the received station?

_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

Reply via email to