Tristani,
Yes, there is a combination of buttons that will set the K3 (or K3S) to
the Factory Defaults.
In the process, several calibration settings are also set to the factory
standard default values - but those values may not be the ones that
exactly match your K3S - there are calibration settings that are unique
to each K3 (K3S).
The process for EEINIT (Parameter Initialization) can be found on page
66 of the manual.
If you have saved a configuration using K3Utility prior to encountering
any problems, you can restore that configuration and the calibration
settings will also be restored. If you have not saved a configuration
when the K3S was operating properly, you will have to go through the
calibration procedures after doing an EEINIT.
Bottom line, save a configuration file on your computer when you get
your K3S and again after making any significant changes. In case of
difficulty, you can then try an EEINIT and reload the last working
configuration and you should be "good to go".
73,
Don W3FPR
On 11/19/2015 8:46 PM, Tristani Ramon wrote:
Is there a button or combination of buttons/actions that can re-set the K3 to
the “Factory Configuration”? After years of tweaking there is strong
probability that one setting is competing against another. Suggestions?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com