If you have a K3 with the old synthesizer, then you will have this
problem with a paddle or with N1MM, or indeed with any source of CW. One
solution is to activate QRQ mode (CONFIG CW QRQ = ON). There are some
limitations, such as not being able to use it with SPLIT or RIT/XIT. The
better solution is to buy the new synthesizer and replace it. In that
case, if you have the second receiver, you need two synthesizers, which
unfortunately will be expensive (especially in Europe).
The K3S comes with the new synthesizer.
I suggest you try sending with a paddle at the speed you want to use to
determine if this is the cause.
There is also a problem with any computer-generated CW that it can be
affected by other processes in the computer, especially if you are
accessing the Internet for spots at the same time. The best solution for
this is to get a Winkey device which will interface with N1MM+ and
generate the CW.
Both of these issues could contribute to the problem.
73,
Vic, 4X6GP/K2VCO
Rehovot, Israel
http://www.qsl.net/k2vco/
On 4 Dec 2015 10:14, Fausto Coletti wrote:
Hi all,
I noticed a problem with N1MM + in CW.
When I select a speed higher than 28-30wpm, the weighing between points and
lines changes and,
at 40wpm the transmitted message becomes incomprehensible.
Any suggestions?
73, Fausto IK4NMF
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
