With this facility, I would consider using a micro controller to implement two functions:
P3 for split mode: Read VFOs A and B. Set center and span so A and B VFOs are on opposite sides of the display. To use, tune in the DX on A and put B just above the pileup. Press the button. P3 for band scanning: Band edge aware setup for fixed spans, e.g. 50KHz, 100KHz 200KHz. Read VFO A. Set span to the fixed span. Set the center so the VFO is near the center of the display and the lower edge is a multiple of half the span above the bottom edge of the band. 73 Bill AE6JV On 1/24/16 at 9:14 AM, d...@nk7z.net (David Cole) wrote: > ... is there a way to trigger the P3 to accept a macro designed for > the P3 itself, using the rear USB connector on the P3? > > In essence, I want to be able to control the P3 via it's own macro set > using the USB connector in the rear of the P3 itself. Is this possible? ----------------------------------------------------------------------- Bill Frantz |The nice thing about standards| Periwinkle (408)356-8506 |is there are so many to choose| 16345 Englewood Ave www.pwpconsult.com |from. - Andrew Tanenbaum | Los Gatos, CA 95032 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
