Sorry for the confusion Phil. This is the question and answer I added a bit of information to. Saw nothing about the Begali Adventure there.
"Q: Can I use a KXPD3 with the KX2? A: Yes; however, you may need to update the KXPD3. If your KXPD3 has one thumb screw that's longer than the other, order part no. E700425 to replace the original left-hand thumb screw on the KXPD3. Use of the original longer thumb screw would damage the KX2." Ron From: Phil Wheeler [mailto:w...@socal.rr.com] Sent: Thursday, May 19, 2016 8:10 PM To: Ron D'Eau Claire; elecraft@mailman.qth.net Subject: Re: [Elecraft] Announcing the KX2 80-10 m, SSB/CW/Data transceiver Ron, Mike's question was "Will the Begali "Adventure" paddles fit the KX2 as well as the KX3?" Is your answer for the Adventure or for the KXPD3? My take is that it's safe to assume that the Adventure screws might be even longer than the longest one on the KXPD3 -- lacking an input from Begali. 73, Phil W7OX On 5/19/16 8:02 PM, Ron D'Eau Claire wrote: Engineering tells me they clear, even with the long tip, but the long one is only a few mil away from an inductor, so a good tightening could end up hitting the inductor and damaging the main board. You can order a second short screw to replace the longer one with. That also eliminates any issues with having the screws in the right locations on the KX3 too. Order E700245. An alert is scheduled to be shipped with every KX2 warning about this issue. In the meantime, the KXPD3 paddles work just fine leaving the long thumb screw loose. At least they do for me! 73, Ron AC7AC -----Original Message----- From: Elecraft [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Phil Wheeler Sent: Thursday, May 19, 2016 5:30 PM To: elecraft@mailman.qth.net Subject: Re: [Elecraft] Announcing the KX2 80-10 m, SSB/CW/Data transceiver Mike, From the KX2 FAQ http://www.elecraft.com/manual/KX2%20FAQ%20v-1-1a.pdf "Q: Can I use a KXPD3 with the KX2? A: Yes; however, you may need to update the KXPD3. If your KXPD3 has one thumb screw that's longer than the other, order part no. E700425 to replace the original left-hand thumb screw on the KXPD3. Use of the original longer thumb screw would damage the KX2." So it appears the Adventure mount will fit, but that we may need to shorten the screws a bit. Not sure what "a bit" is! 73, Phil W7OX On 5/19/16 3:16 PM, Mike via Elecraft wrote: Will the Begali "Adventure" paddles fit the KX2 as well as the KX3? Mike KD8RQE ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com