Larry, Thanks! 200W is probably a bit on the high side for my needs (safety margin), so this looks pretty good.
-Michael -----Original Message----- From: Larry Phipps [mailto:[EMAIL PROTECTED] Sent: Tuesday, March 07, 2006 10:29 AM To: Linden, Mike (BRC-Hes) Cc: elecraft@mailman.qth.net Subject: Re: [Elecraft] CP1 Power Handling A quick check shows that no small size cores will work for -43 material with 10T at 1.8 MHz and 200W. However, FT50B cores come close, and are fine at 3.5 MHz. FT50B is twice the thickness of the FT50A, and would fit on the board because the thickness would only add height. 73, Larry N8LP Linden, Mike (BRC-Hes) wrote: > Larry, > > If you have the time, I'd certainly appreciate it if you'd run it > through your spreadsheet for me. > > Thanks! -Michael > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com