Stewart,
The message really means, "Something of sufficiently low impedance to
common is attached to the auxbus, holding the auxbus line at a logical
low. Turn on the device if it is off -- this is the most common cause
of the problem -- or disconnect the device from the auxbus."
The symptom first showed up consistently during KPA500 development, so
the error message suggests turning on the KPA500.
In your case, I'd say, "Keep calm and carry on."
73,
Lyle KK7P
I have a K3 connected to an XV144 in the preferred configuration shown
in the manual with the AUX port used for band switching.
Occasionally I find that with the XV144 powered down the K3 hangs
complaining that the KPA500 needs to be turned on. I can cure this by
powering on the XV144 or by disconnecting the Aux lead from the XV144.
Is this a fault on one of my component's (K3, cable or XV144), a bug
or a feature.
Any idea where I should start to debug?
Thanks
Stewart/G3YSX
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
