Hi Don.
Thanks for the info.
I performed the 1 Amp mod on my K3 myself, so I'm quite sure it's 1A capable
and yes it does have the 1A label.
I'll look for a quality adapter. As they're normally meant for audio work, I
was a little concerned that the internal wiring might only be intended to
carry milliamps.
73,
Alan. G4GNX
-----Original Message-----
From: Don Wilhelm
Sent: Sunday, November 19, 2017 12:04 PM
To: G4GNX ; Elecraft Reflector
Subject: Re: [Elecraft] P3 with SVGA
Alan,
Look at the label on your K3 12 volt output jack. Does it say 0.5 amp
or does it say 1.0 amp? The 12v change includes a sticker to re-label
the jack.
Yes, you could use a "Y" adapter, but use a good quality one so you
don't have a significant voltage drop due to loosely fitting connectors.
73,
Don W3FPR
On 11/19/2017 6:49 AM, G4GNX wrote:
I just assembled the P3 kit which includes the SVGA adaptor and the TX
monitor.
In the original instructions, there’s a warning not to use the P3 with
SVGA adaptor, taking power from the K3’s 12 volt output. However, there’s
a reference to the 1 Amp K3 modification in a later full manual for the
P3, which says it’s OK to use the P3+SVGA, provided older K3s have the 1
Amp mod.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com