Hi Dany. This scared me a little bit too until I figured out what it was for.
This is not just for expeditions. It's for everyone to use whose rig can handle it. Your TX frequency will still be as indicated on the FT8 screen. The software will raise the audio tone frequency by the same amount that it drops your VFO B so that your tone is in the right place. By doing this, the audio tone frequency is kept high enough that its harmonics will be out of your FT8 passband. This is good -- it helps keep the band clean. See section 4.2 in the wsjt-x user guide. 73, Carl WS7L On Mon, Dec 4, 2017 at 3:59 PM, Dany VE2EBK <ve2...@hotmail.com> wrote: > Hi > > I would like to know if someone tried to run WSJT-X FT-8 in Split mode, > not Split in the audio band but in real Split by activating the option in > the radio tab of the configuration? > > Here, when I activate Split option, K3 change for Split, RX stay on VFO A, > TX change to VFO B but TX frequency drop of 1 kHZ ! If I turn the VFO B > (TX) 3 kHz up for example, the VFO B return 1 KHz down when a transmission > start (TUNE is enough). > > This option seems to have been for the DX station rather than for use. > > It would be nice to check this before the 3Y0Z DXpedition that during ... > > 73 > > Dany VE2EBK > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to clawso...@gmail.com > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
