Hi Wayne: Recently I had a problem with my PX3. The VFO A cursor bar was black instead of green and some other artifacts. Elecraft support said it was probably the LCD and I would have to replace the front panel board and LCD at a cost of over $500. I consequently bought a used PX3 at much less than $500. I still have the PX3 with the "defective LCD". I would still like to get it repaired if it's around $100 or so. :-)
73, John N1JM wayne burdick wrote > John_N1JM, wrote: > >> It's a good thing it's under warranty. A screen from Elecraft parts is >> $500+. > > Hi John, > > Reliability of the PX3 front panel circuit board and LCD is extremely high > (ditto with the P3). We do get an occasional request for LCD replacement, > usually after the PX3 has been operated portable and sustained damage in > transport. > > The bezel (~$21 replacement cost) usually takes the brunt of the damage. > If a new LCD is required, it's ~$100. Replacement instructions can be > found in the PX3 Owners Manual. > > I don’t think we’ve ever had to replace an entire PX3 front panel module. > We could repair it in virtually any scenario short of grizzly attack. > > 73, > Wayne > N6KR > > > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto: > Elecraft@.qth > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to > lists+1215531472858-365791@.nabble -- Sent from: http://elecraft.365791.n2.nabble.com/ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
