Glenn,
The errata sheets always supersedes the manual - it is the latest
update/correction. The designation on the errata title carries the
manual designation that is to be corrected.
Go to the Documentation download page to be certain you have the latest.
73,
Don W3FPR
On 7/14/2018 10:41 AM, WA7SPY wrote:
The K3S and options are all working. I had a problem with 2meters being off
frequency after adding the K3EXREF and the K144XV reference board. I did a
complete reset to factory defaults. I removed the K144XV reference board. Then
set the 2 meter offset back to what was labeled on the module. The 2 meter
frequency was accurate. I put the K144XV reference board back in. Now the 2
meter frequency is accurate with the board back in. My question is where is the
TMP cable suppose to be connected on the KSYN3 board? I have one end connected
to REF IN on the 2 meter module. I initially connected the other end to J4 on
the KSYN3. I now have it connected to J1 on the KSYN3 do I have the TMP cable
connected correctly? The documentation is a little confusing to me. Figure 13
page 15 on the K3EXREF manual shows J4 being used on the KSYN3A if both the
KXV144 reference board and the KEXREF options are installed. There is an Errata
sheet showing to use J1 on the KSYN3 board. Which one is c
or
rect to use for my set up J1 or J4?
The K3EXREF is working with very accurate frequency on the HF bands with my GPS
10 MHz disciplined oscillator clock connected. The 2 meter frequency was off
when connected to J4. I am not sure if it was corrupt software and doing the
reset corrected the issue and am uncertain where to connect to on the KSYN3A
board?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
