I plugged the REF IN TMP cable to J4 on the Main KSYN3 board per the diagram on page 15 of the K3EXREF installation and operations manual. The 2 meter frequency is off according to the K3S display and verified being not centered with my P3. If I plug the REF IN TMP cable into J1 on the Main KSYN3 board the 2 meter frequency is centered and accurate also verified with my P3. I used a local repeater and tried simplex with my Yeasu FT - 60 and the two meter displayed on the K3S is off center with distorted audio if I plug the TMP cable into J4. If I plug into J1 audio sounds great and the K3S displayed frequency is centered with my P3. So I assume J1 is the proper connection? I have an email into tech support about this.
Glenn Maclean WA7SPY > On Jul 14, 2018, at 12:00 PM, Don Wilhelm <donw...@embarqmail.com> wrote: > > Glenn, > > The K3EXREF manual is dated later. The other document does not include the > K3EXREF and would apply only if the K3XREF were not installed. > > 73, > Don W3FPR > >> On 7/14/2018 12:02 PM, WA7SPY wrote: >> Hi Don, >> I understand about the Errata. The confusion is the Errata is for the KXV144 >> Reference module dated Dec 5 2013 showing placement at J1 on the KSYN3A. The >> K3EXREF manual is dated August 23, 2016 and shows placement at J4 on the >> KSYN3A. Hence confusion? >> Glenn Maclean WA7SPY >> >> >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com