Good advice. Also be aware that the center frequency differs depending on mode. For example, it is the supressed carrier frequency on SSB but is offset by typically 600 Hz on CW.
I like to use AM mode for frequeny calibration. After doing a frequency calibration on the K3, tune to a signal on the AM broadcast band and adjust the P3 frequency calibration. (MENU:RefCal. Cal procedurre is on page 39 of the manual) As I recall, AM broadcast stations are required to be within 20 Hz of nominal frequency but are typically much closer than that. Alan N1AL On 2019-07-23 08:20, Bob McGraw K4TAX wrote: > First make sure the radio is correct on all WWV frequencies. I use CW mode > and Auto Spot. That will get to within 2 Hz or better. Adjust the Ref freq > to calibrate. > > Then you can calibrate the P3 to the radio. > > No tuning or listening for zero beat required. > > Bob, K4TAX > > Sent from my iPhone > > On Jul 23, 2019, at 9:54 AM, Kevin, N4TT <kkinde...@gmail.com> wrote: > > Hi Jim: > > I thought I had the right adjustment on the P3 but it seems global. I can't > figure out why WWV can be spot on and then another signal off. I can't even > be sure if it is the radio or the P3 (or me) at this point. I'll keep > digging. > > Kev > > On Tue, Jul 23, 2019 at 3:57 AM Jim Brown <j...@audiosystemsgroup.com> wrote: > > It's been a while since I looked at the manuals for my K3 and P3, but I > do recall that there are calibration procedures for both. > > 73, Jim K9YC > > On 7/22/2019 9:28 PM, Kevin, N4TT wrote: > I noticed my P3 doesn't seem to be zeroed with the K3s. When I tune in a CW > signal with a 600 Hz pitch the P3 is off by 71 Hz. Not much but, I > expected - zero. > > In AM - WWV at 5 MHz the P3 seems spot on. > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to kkinde...@gmail.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to rmcg...@blomand.net ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to a...@elecraft.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com