Thanks, Mike WØVTT, the problem is resolved! Mike asked if I had checked the firmware, which I had previously and had determined earlier that I had the latest version [05.67]. Thinking it couldn't hurt to reinstall it anyway, I did, and that solved all issues! Now everything works as it should.
Thanks to all who spent time and effort trying to get to the solution. Dunno what the problem was, but since it is all electronic stuff, anything could have gone wrong. 73 Madison W5MJ On Fri, May 22, 2020 at 9:42 PM Nr4c <n...@widomaker.com> wrote: > “MODE”? > > Sent from my iPhone > ...nr4c. bill > > > > On May 22, 2020, at 10:23 PM, Madison Jones <w5mikejul...@gmail.com> > wrote: > > > > Hi Don > > > > I checked VOX, and it is on and has been on. I tried the paddles in the > key > > jack of the K3. Nothing happens. I tried in the paddle jack of the K3. > > Nothing happens. However, the paddles, with or without MORTTY, and with > and > > without N1MM, work fine in the Kenwood TS480 in both the key jack and the > > paddle jack. > > > > I conclude, therefore, that the paddles are functional, that MORTTY is > > functional, and that N1MM is functional. The K3 is NOT functional. Since > > this is the Elecraft forum, I am asking that perhaps someone on the > > reflector has a new idea since I am out of old ideas. > > > > Anyone else? > > > > Madison > > W5MJ > > > >> On Fri, May 22, 2020 at 6:43 PM Don Wilhelm <donw...@embarqmail.com> > wrote: > >> > >> Madison, > >> > >> Eliminate everything except the K3 and your paddles. > >> > >> Plug the paddles into the paddle jack on the K3 - does the K3 make CW? > >> Then plug the paddles (assuming you do not have a straight key) into the > >> KEY jack. Do you have a 'straight key' on one side of the paddles?. > >> If both those conditions are OK, then the K3 is OK. > >> Look to a problem with MORTTY or your computer application. > >> > >> Once you have identified the source of the problem, then you can address > >> it with the appropriate forum for that particular piece of the puzzle. > >> If it is the K3 that is misbehaving, then email supp...@elecraft.com > for > >> assistance. > >> > >> 73, > >> Don W3FPR > >> > >>> On 5/22/2020 6:25 PM, Madison Jones wrote: > >>> Thanks to everyone. The entire configuration which I described has > worked > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com