I'm a T1 owner and I use the 44 and 88 foot dipoles. I can say with
experiance that everything Ken says is true. You just can't do better.
73 Karl
Kenneth A. Christiansen wrote:
Hi from Fargo, ND and many camp sites.
This is the antenna I have used for the last 5 years in my camper with
I feel excellent results. It is a 44 foot doublet (22 feet) on each
side of center) with a feed line of 22 feet of 450 ohm window line.
The center is supported by a 23 foot telescoping painter's handle with
a hook at the top made out of an old paint roller. The ends are
supported by 10 foot lengths of 3/4th inch PVC pipes to make an
inverted vee.
This loads well with either my KAT2 or KAT100. I added a W2DU 1 to 1
balun and I find the antenna so stable the settings the tuner picked
from the last camp site usually work at the next camp site with no
changes. I have a 1 foot jumper of RG8 between the tuner and the
balun. This works as is on all bands except 30 and 80 meters. On 30
meters 22 feet of feed line is a bad length and transforms the low
impedance of what is a 30 meter dipole to a high impedance which gives
the tuner trouble. I cut a jumper of 22 feet of 300 ohm twin lead and
wound it into a coil with a 7 inch diameter. All my twin lead feed
lines use alligator clips so to use 30 meters I just clip the
additional 22 feet loop of feed line in series with the 450 ohm window
line.
I have 22 foot extensions I can add to each side of the doublet to
make it 88 feet for use on our 75 meter SSB net. These extensions have
to be tied to a tree or other support but the 44 ft doublet is self
supporting by the 23 foot painters handle on the hitch of my camper
and the 10 foot PVC pipes which are supported by the rear bumper of
the camper and the front bumper of my tow vehicle.
If I want to work 160 meters or don't have a location where I can add
the 22 foot extensions for 75 meters I have a loading coil and can tie
the two sides of the 22 foot feed line together and use the loading
coil to make a top loaded vertical which uses the frame of my camper
as a counterpoise and that works about as well as a good mobile station.
I used to use a home made full wave quarter wave vertical on 20 meters
which used the frame of the camper as a counterpoise. I thought it
worked well but in 2001 the 44 ft doublet was brought up here on this
reflector. I built it and used both antennas for just two camping
trips. The doublet was so much better than the vertical that I quit
taking the vertical along. I have run QRP battery 1B for the last 5
field days and the weak point is me as an operator and not my station
or antenna.
Last week end I was set up at Fort Ransom State Park, ND. I worked
W1PID on 20 running 3 watts on a K1 and 88 foot doublet (I was running
the 100 watts). I QSYed to 30 meters and ran 5 watts on my end and had
a 25 minute QSO with K4AKC who was running a K1 and 4 Watts to a G5RV.
When we got done CU2BV from the Azores called me and we had a 15
minute QSO down at 13 wpm and I was still running 5 watts.
I have been camping and portable for about 39 years and used many
different rigs and antennas but nothing I ever had before has worked
as well with as little effort on my part as the K2/100 and 44 ft doublet.
I hope more of you try this antenna and have as good luck with it as I
have had.
73 from North Dakota where it is now 94 degrees F headed to -30
degrees F in just 6 months.
Ken W0CZ [EMAIL PROTECTED]
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
