Hi Dave,
Another possibility is that perhaps one of the display connectors has
come loose or is making a bad connection.
I normally wouldn't recommend this since these tiny connectors are kind
of tricky, but since the P3 isn't working anyway, there's nothing to lose.
There are two surface-mount connectors located underneath the display on
the front-panel board: a 4-pin connector for the display backlight and a
40-pin connector for the rest of the display electronics.
To access them, remove the front-panel board from the P3 and then remove
the LCD display by gently prying it free from the rubber holder. Be
careful so as not to put stress on the flex circuits going to the two
connectors.
Examine each of the connectors to see if it looks like the flex circuits
are properly seated in them. To re-seat one, open the connector by
using a fingernail to pop open the top. After re-positioning the flex
circuit, press the connector top down again until it clicks.
As I say, this is a rather delicate operation (which is why the front
panel came pre-assembled in P3 kits). So you might want to consider
sending the P3 in for service and let the experienced Elecraft techs
handle it.
Alan N1AL
On 2/24/23 10:51, Dave New, N8SBE wrote:
Mike,
Thanks for the idea! I hadn't considered that mitigation.
Anyone else have ideas for a permanent corrective action?
73,
-- Dave, N8SBE
On 2023-02-24 09:13, Mike Flowers wrote:
Hi Dave,
If you have a way of sending P3 control commands to the P3, there may
be a
chance that you could the resolution of the external display set to a
useable value.
I've attached my copy of the P3 Programmer's Reference.
- 73 and good DX de Mike, K6MKF, NCDXC Life Member
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to a...@elecraft.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com