Merry Christmas Keith! Thank you for all you provide here.
Agreed. So to help make it clear; what *MUST* be done by EACH (US!)
operator on 60M is:
* figure out the gain/loss for each antenna being used (MODEL it).
That gain/loss value times watts is used to
* adjust the output power for the max/wanted ERP for the band
*_/SEGMENT/_* in use
* to stay within the band SEGMENT limits (100 watts ERP for the 4
channels, else 9.15 watts ERP)
* AND keep the bandwidth under 2.8 KHz.
Or just run QRP all the time which pretty much sucks for DXers, no
significant changes except the 'all-but-US' filter for the EU teams (was
out of band) is now gone (IF one can get through on QRP).
This takes effect 30 days AFTER being posted in the Federal Register
(wait for it, likely mid-Jan plus/minus holiday latency for posting).
I'm sure SOMEONE will post when it is published. NOT before, the ARRL
cops will be checking (another Charlie Foxtrot).
A-Z at 100 watts ERP would have been SO MUCH simpler (what I pushed
for); but here we are; complications.
73 all ya'll,
Rick nk7i
On 12/12/2025 11:32 AM, Keith Trinity WE6R via Elecraft wrote:
Elecraft radios are not channelized.
The rule change did not change the upper and lower limits, so nothing
to worry about.
It is up to you to know the rules and operate accordingly within the
band.
Personally I program frequency memories with the editor for 60m
(channelized channels) for my K3.
That way you can just change channels and no worries.
https://elecraft.com/pages/elecraft-frequency-memory-editor-software
Keith WE6R K3/K4 Tech
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
