Andrew,
With the KPA100 installed, and the power set to 10 or 11 watts, what is
the actual power output in TUNE?
It should be near 2 watts.
If not, there is a problem in the VRFDET section of the KPA100 or in the
base K2.
First, remove the KPA100 (physically) and try it with just the base K2.
If the base K2 is OK, then yoou have some KPA100 problem to solve. Put
the KPA100 upside down on a box or book about 1/2 the height of the K2
and remove the shield.
set the power to about 50 watts and prepare to do some voltage measurements.
Measure the voltage at U5 pin 5 - then at 5 pin 7, they should be close
to the same voltage.
U6 pin 3 should be about 1/2 that voltage. If not, the problem is Q10
and possibly Q11.
If all OK this far, then make certain U6 pin 8 is near 5 volts.
If so, then check U6 pin 6 and tell me what the voltage there actually
is. U6 is a common failure.
73,
Don W3FPR
On 7/26/2026 1:16 PM, Andrew Lenton via Elecraft wrote:
Hi I have just performed all the mods on the KPA100 and reset the FWD
and REF and set the bias at 400mA, my bird watt meter tracks the
indicated power on the K2
After fitting the screen and putting it all back together it works
fine on SSB.
On low power tune is fine, however on more than 11 Watts pressing
tune causes the power to jump to 140 and the SWR 2.2:1, so suspecting
it is "hooting" when all back together.
Before I dive in an suggestions?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
