Trev,
By 'clipped' do you mean an actual clipped waveshape? If so, check the
two capacitors mounted on the back of the Control Board at U10 and Q8.
These are associated with the Keying Waveshape circuit and if not
connected to the proper points will distort the normal keying waveshape.
73,
Don W3FPR
TREVOR WATERS wrote:
! wonder if anyone can help? I have a k2 No 5914. The
problem concerns when sending cw the dits and dahs
seem to be clipped making it very difficult to send
good morse. I suspected rf getting into some part of
the rig but I have change antenna to a dipole,
grounded the case of the K2 but the problem persists.
I have also ajusted the weighting in "dot" but still
the problem remains. Any help would be most welcome.
By the way. Here the nail biting begins. Just ordered
K3. Fingers will never last until Nov.
Regards to all.
Trev GW4IMC
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
