I am still troubleshooting my KAT100, and now I am wondering if the problem might be the aux bus.
When the 9-pin connector is attached to the K2, and the KAT100 is disconnected - should there be 5-6 volts DC on pin 6 ? I see voltages on pin 8 and 9, but nothing on pin 6. (And yes i verified the cable is ok on pin 6). I had previously checked the DC path from pin 6 back to the IOC in the K2 - but I hadn't probed this any further. I suspect there are no other users of the Aux Bus except an ATU (my K2 has only ssb, 160m and kpa100 installed). Info appreciated. ____________________________________________________________________________________ Looking for last minute shopping deals? Find them fast with Yahoo! Search. http://tools.search.yahoo.com/newsearch/category.php?category=shopping _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com