Just a curious question. Since you are using a K3 and that radio has 6
meter (50 MHz) coverage included, why are you trying to use an add-on
transverter?
Jim KD5VXH
----- Original Message -----
From: "Phil Theis" <[EMAIL PROTECTED]>
To: <elecraft@mailman.qth.net>
Sent: Tuesday, March 18, 2008 9:23 PM
Subject: [Elecraft] 50MHz Transverter
Given the following setup: K3 using transverters, with 50MHz transverter
set for xv1.
When I enter a 50MHz frequency via the com port the built in 50MHz
receiver is selected. I then have to band up once to get to the xv1, then
I can successfully band up to 144 etc. If I enter a 144 frequency, it
immediately goes to xv2.
What would it take to get a serial command to go to a frequency in 50MHz
range to go directly to the xv1 selection?
thanks
Phil K3(352)TUF
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
