Jerry, The KSB2 Adapter operating instructions (page 22) indicate that CAL CUR should be set to a maximum of 3.5 amps. Mine is set to 3.5 amps and under some conditions I get an HI CUR using a Heil ICM microphone. I use the lower mic gain setting and the K2 seems to work very well.
Robie - AJ4F On Sun, Mar 30, 2008 at 7:19 PM, n0jrn <[EMAIL PROTECTED]> wrote: > Hi gang: > > One other question to insure I am not setting myself up for disappointment. > :-) > > When you use CAL CUR to set the current limit, is there a limit to how > high one can go without jeopardizing the rig?? > > My K2 has the KSB2, KDSP2, KNB2, KAT2, KBT2, KIO2 & K160RX > installed. > > When I key the rig with it set to 10 watts out, I'm getting about 2.8 > amps of draw. I didn't figure that was unusual with all the options on > board. BUT it kept giving me a high current warning when I first key up > and it appeared to be cutting my output back. So, I went into CAL CUR > and raised the current limit to 3.0 amps. > > Initial setting per the manual was 2.5 amps. > > Just wanted to be sure I wasn't going to burn the house down........ > > What cha think ?? > > 72 Jerry N0JRN > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
