Good point, Vic. Didn't check that, but I remember seeing it mentioned somewhere before. I'll check that in the morning. It would certainly go along with my idea that I just pushed something in the wrong way :-) Thanks and 73 Bob N6WG
----- Original Message ----- From: "Vic K2VCO" <[EMAIL PROTECTED]> To: "Robert Tellefsen" <[EMAIL PROTECTED]> Cc: "Reflector Elecraft" <elecraft@mailman.qth.net> Sent: Saturday, May 03, 2008 10:18 PM Subject: Re: [Elecraft] K3--Keying suddenly stopped > Robert Tellefsen wrote: > > I was working the 7th District QSO Party, and doing fairly well > > at 5w on both cw and ssb. Then, just after I logged my 103rd QSO, > > the keying stopped. > > > > Neither the paddles nor the computer coming through the key jack > > will cause a signal to go out in cw mode. Keying the paddles does > > give cw sidetone and the red TX light over the headset jack lights in > > time to the keying. I've cycled through the TEST mode several times, > > but to no effect. > > > > Holding the XMIT/TUNE button does cause a carrier at normal power. > > Using > > either VOX or PTT on ssb generates a normal signal > > Remember that VOX has to be ON in CW mode if you want closing the key to > put you into transmit mode. > > -- > 73, > Vic, K2VCO > Fresno CA > http://www.qsl.net/k2vco _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com