Yes, that was it, Vic.
Apparently when I toggled the mode switch between ssb and cw
I must have also dropped the VOX selection.
I think this is an unfortunate control arrangement.  I'd rather see a
menu selection for this if it is necessary and get it off the button
where it can be changed by accident.
Thanks and 73
Bob N6WG

----- Original Message ----- 
From: "Vic K2VCO" <[EMAIL PROTECTED]>
To: "Robert Tellefsen" <[EMAIL PROTECTED]>
Cc: "Reflector Elecraft" <elecraft@mailman.qth.net>
Sent: Saturday, May 03, 2008 10:18 PM
Subject: Re: [Elecraft] K3--Keying suddenly stopped


> Robert Tellefsen wrote:
> > I was working the 7th District QSO Party, and doing fairly well
> > at 5w on both cw and ssb.  Then, just after I logged my 103rd QSO,
> > the keying stopped.
> >
> > Neither the paddles nor the computer coming through the key jack
> > will cause a signal to go out in cw mode.  Keying the paddles does
> > give cw sidetone and the red TX light over the headset jack lights
in
> > time to the keying.  I've cycled through the TEST mode several
times,
> > but to no effect.
> >
> > Holding the XMIT/TUNE button does cause a carrier at normal power.
> > Using
> > either VOX or PTT on ssb generates a normal signal
>
> Remember that VOX has to be ON in CW mode if you want closing the
key to
> put you into transmit mode.
>
> -- 
> 73,
> Vic, K2VCO
> Fresno CA
> http://www.qsl.net/k2vco

_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

Reply via email to