There has always been some watery distortion on my SSB signal from my
K2/100.
It is there with or without the KPA100.
It is there with three different mikes.
It is there with two different KSB2 modules.
It is there on both upper and lower sideband.
The CW signal sounds pretty good, no obvious problem.
The SSB distortion is not real bad, but noticeable.
The ALC is high and has a hard time settling down on 80M. It settles to
two bars but may start at 6 or 7 bars.
The ALC on 10M is just one bar.
The watery distortion is on all bands 80M thru 10M and into a dummy load.
I assume the problem is not KPA100, KSB2, mikes, or RF getting in. The
problem has been there for years (sn 3194) but has worked it's way up
the fix list. At this point I'm not sure where to start.
Suggestions welcomed!
73 de K1ESE
John
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
