Hello John If you have another ssb receiver available that can tune to the K2 IF frequency, try listening to ssb directly out of the KSB2 and see if it is watery there. If not, the problem lies elsewhere in the rig. If it is watery, which I doubt it will be, since you say you get the same result with two different KSB2 modules, then the problem may be in the KSB2s. Also check the stability of the oscillators by listening to them. Is there any warble at all in their frequencies? Good luck and 73 Bob N6WG
----- Original Message ----- From: "John Huffman" <[EMAIL PROTECTED]> To: "Elecraft List" <elecraft@mailman.qth.net> Sent: Friday, May 16, 2008 7:12 AM Subject: [Elecraft] K2 SSB Watery Audio Distortion > There has always been some watery distortion on my SSB signal from my > K2/100. > > It is there with or without the KPA100. > > It is there with three different mikes. > > It is there with two different KSB2 modules. > > It is there on both upper and lower sideband. > > The CW signal sounds pretty good, no obvious problem. > > The SSB distortion is not real bad, but noticeable. > > The ALC is high and has a hard time settling down on 80M. It settles to > two bars but may start at 6 or 7 bars. > > The ALC on 10M is just one bar. > > The watery distortion is on all bands 80M thru 10M and into a dummy load. > > I assume the problem is not KPA100, KSB2, mikes, or RF getting in. The > problem has been there for years (sn 3194) but has worked it's way up > the fix list. At this point I'm not sure where to start. > > Suggestions welcomed! > > 73 de K1ESE > John > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com