Am 06. Oct 2008, um 14:01:35 schrieb Eric Swartz - WA6HHQ, Elecraft: > Hi Toby, > > We had a change in PCB vendors, and they slightly changed the location > on some of the break-off points for the PCB handling frame on the KRX3 > board (used during automated soldering etc. ) Fortunately this is not a > major issue. The other remaining 'nubs' from the break off part of the > pcb still align with the remaining alignment holes on the KRX3 case. The > ones that do not are not a problem.
Eric, I've complained to [EMAIL PROTECTED] about the poor quality of the PCB cutting as well. Not only do I have the same problem as Toby, but I also had to trim the LPA board so that it would fit. For the KRX3, What is your suggested solution -- push in the board by force, or remove the misaligned "nubs" ? (I went for a) given I had the board already half in, but the problem I have is a "hash" when turning the VFO knob, which could be shielding issues.... Mario -- Mario Lorenz Internet: <[EMAIL PROTECTED]> Ham Radio: [EMAIL PROTECTED] "I hear that if you play the NT 4.0 CD backwards, you get a Satanic message!" "That's nothing. If you play it forward, it installs NT 4.0!" _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com