I don't see a problem with CW on my K3 (29.4W measured, 30W requested,) but there are definitely still problems with excessive power output in DATA-A. DATA-A initially output the correct power, but after switching to AFSK-A and back to DATA-A, I get well over 2x the requested power out (71W measured vs 30W requested.)
73 -- Joe KB8AP On Feb 11, 2009, at 6:16 AM, steven.zabarn...@notes.udayton.edu wrote: > > I installed the new beta last and tested the new output power > control. I > don't see any improvement in PSK31 output power using DATA A mode. I > still > get nearly twice the output power than I have dialed in by the PWR > knob. In > the previous firmware, the measure output power in CW modes agreed > with the > PWR knob setting, but now the power output in CW is 20-30% higher > than the > setting. > > I will try to redo the transmitter gain calibration to see if this > helps. > > Steve N9SZ > K3 #1672 > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html