I find that the key to removing SMT components like those involved in the mods described is best done with solder-wick and quick movement of one small-tipped iron to both ends of the component. I removed most of the solder with the solder-wick and then alternate heating of both ends of the component until it lifts up from one end. It then becomes a matter of heating the remaining end and plucking the old part off with the iron's tip. Then, clean the pads with the solder wick and install the new component.
Being able to see is crucial, and loads of task lighting is helpful. 73, Bob W5OV ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
