Hi, No, please, this is not a power calibration issue! A huge number of K3 users have complained about this propensity of the SSB power to aim "conservatively" for 50-80% of the requested peak power and then slowly, very slowly climbing up to the requested power. Once reaching 100% it stays there until you perform some kind of QSY operation other than just turning the wheel. It is not a huge irritant to me, but an irritant nonetheless. If I am in a big rush to have full power on SSB after a QSY, I switch mode to TX data FSK D, do a quick squirt of TX and I have instant full SSB peak power.
AB2TC - Knut Joe Subich, W4TV-4 wrote: > > > >> When I whistle to mic and tune my linear amplifier, I notice >> that last watts going up very slowly. Without linear I tested >> and sometimes first 80 watts out normally but from 80 to 100 >> watts it takes about 2-3 seconds. > > Sounds like a power calibration issue. Double check the K3 > wattmeter calibration, the amplifier gain calibrations and > TXG VCE. > > 73, > > ... Joe, W4TV > > <snip> > -- View this message in context: http://n2.nabble.com/K3-power-output-on-SSB-tp4818879p4821485.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html