My personal rule for torque-wrenching small allen screws (once I know threads are clear) is "pinky pressure".
I turn the allen wrench until it *just barely* runs into resistance. Then I put my pinky on the wrench and let some of the weight of my forearm (no pushing) tighten it up. Should not ever be stripping allen wrenches in K3 RF/AF knobs. The replacement knobs I got for the flawed early batch that came with my K3 have been just fine. 73, Guy. On Tue, May 11, 2010 at 8:21 PM, Tom W8JI <w...@w8ji.com> wrote: > >> My experiences are different. For small knobs you need to >> use high >> quality wrenches. Those .050 do work if you have a good >> one. It's >> amazing how much twist you can put in a high quality Allen >> wrench >> while trying to deal with a stubborn screw. > > I would not ever force the screw. That is just asking for > problems. > > Off the shaft and on the table, run it in until it resists > turning and then back out. Do that several times cleaning > the threads out. > > >> As an old-timer I dealt with many a slotted set screw. >> Nothing but >> headaches. > > No truer words were ever spoken!!! The last thing I would > want is phillips, and then second last would be slotted > screws. > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html