Paul, Not quite enough information yet to give you a positive answer. Are you using the KAT2 in the ATU CAL menu setting? If not, what do you have connected to the ANT jack(s) - hopefully a dummy load. If it is other than a dummy load, what happens with a dummy load attached? Did you obtain a good null when you balanced the KAT2 wattmeter? If not, that is the starting point, even if that is not the problem source.
73, Don W3FPR Paul Locker wrote: > I have just finished the installation of my kat2 I got at Dayton. I am > seeing a > high current warning for any band I use above 2 watts. I tried the other > antenna position and noticed it resulted in a different swr. I changed my > ground and that didn't improve the high current warning as I read in the > manual > that it could be an issue. > > > Is there anything specific I need to check or do to start my troubleshooting? > > Paul > k4pml > > > "Don't forget to take the right Path" > > -JRDL > > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html