Both LEDs stay lit the whole time and I made sure to flash the board with the latest MBM firmware. I came to the same conclusion that there maybe something wrong with my board. I tried email [email protected]<mailto:[email protected]> to use the warranty but the email just bounces back. The email does not seem to exist. I'm not sure who to connect now.
Steven On Oct 26, 2014, at 12:28 PM, Timothy Hurita <[email protected]<mailto:[email protected]>> wrote: Do both LED's stay solid the whole time or does one of them start blinking? The MBM can be a bit picky about power and the LED closest to the SATA port will blink if that's the case. Don't take this question personally but did you flash the latest Minnowboard Max firmware or the Minnowboard v1 firmware? I ask only because I've seen some folks get the two mixed up. The latest MBM firmware is v0.73. https://uefidk.com/content/minnowboard-max If the firmware is correct and both LED's remain solid, and your sure that the HDMI cable and monitor are good then it does sound like there might be an issue with your board based on the debug output and the way it's acting. Tim _______________________________________________ elinux-MinnowBoard mailing list [email protected]<mailto:[email protected]> http://lists.elinux.org/mailman/listinfo/elinux-minnowboard _______________________________________________ elinux-MinnowBoard mailing list [email protected] http://lists.elinux.org/mailman/listinfo/elinux-minnowboard
