maybe if you can get a copy of the current firmware and the version just prior to that you could start by flashing the prior version just to test. if that version works you could keep it or try flashing the latest to see if anything changes with that version. On Wed, May 2, 2018 at 1:52 PM Rick Thomas <rbtho...@pobox.com> wrote:
> I do the following: > 0) start with a plain-out-of-the-box dual core minnow board with a 2 Amp power supply and an HDMI monitor attached. > 1) remove all USB and SD modules > 2) connect a keyboard and mouse to the top (USB2) slot via a powered hub > 3) unplug the power to the minnowboard then re-plug it, and hit F2 many times > Result: there is no response to the keyboard or mouse. It runs the memory check then goes to the UEFI shell (which shows no devices). I try to type “exit” and there is no response. > Variations: > 4) Plug the keyboard (without a mouse) directly into the top plug (USB2) and repeat. Again same — no response to the keyboard. > 5) Plug the powered hub with keyboard and mouse attached into the bottom (USB3) plug. Same — no response to keyboard. > 6) same as above with a USB stick holding Ubuntu installer plugged into the powered hub (or directly into the lower slot or even directly into the upper slot — with the keyboard plugged into the other slot) — Same. > But: > 7) If i insert an SD card with Ubuntu installed on it, and unplug/replug then it will boot to Ubuntu (again, no response to the keyboard during UEFI phase). Under Ubuntu, the keyboard is live — just as normal for Linux. > And: > With Ubuntu running, I can tell Ubuntu to reboot. And (lo and behold!) if I hit the F2 key while it is rebooting the keyboard is live and I get dropped into the BIOS boot menu. I can then use the keyboard to choose to boot from either the Ubuntu SD card or a USB stick with the Ubuntu installer, or anything else I might wish. Magic! > So… I’m guessing that Ubuntu does some kind of initialization on the USB hardware that survives the reboot as long as the power is not removed. But unplugging the power causes that initialization state to be reset and the keyboard goes inactive until the next time it boots into Ubuntu. > It’s starting to sound like a firmware bug… > If so, I’ll be happy to work with the engineers to debug it and test a fixed firmware version. > Enjoy! > Rick > _______________________________________________ > elinux-MinnowBoard mailing list > elinux-MinnowBoard@lists.elinux.org > http://lists.elinux.org/mailman/listinfo/elinux-minnowboard _______________________________________________ elinux-MinnowBoard mailing list elinux-MinnowBoard@lists.elinux.org http://lists.elinux.org/mailman/listinfo/elinux-minnowboard
