On Mon, 2008-07-07 at 09:33 -0400, John Kasunich wrote: > Jon Elson wrote: > > > The other thing is I used to barely understand the G10 L2 Px > > behavior before, and it seems to have changed. I think in the > > EMC1 past, all G55 - G59.3 work offsets were relative to the G54 > > system, > > That seems rather insane. G54 is no different than G55 or any of the > others, it isn't some special "master" coordinate system. If all the > others were based on G54, then moving 54 would move everything, which > IMO would be a very unexpected result.
I had similar thoughts about g54. I know that g92 acts as a super coord shifter but had not seen g54 act that way. Rayh ------------------------------------------------------------------------- Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW! Studies have shown that voting for your favorite open source project, along with a healthy diet, reduces your potential for chronic lameness and boredom. Vote Now at http://www.sourceforge.net/community/cca08 _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
