Chris Radek wrote: > On Mon, Jul 07, 2008 at 02:22:48PM -0500, Chris Radek wrote: > >>Deja vu! You must run this gcode once every two years! > > > Err 2008 - 2007 = ?? > > Every summer then. I hope that old link helps. Interesting how this comes up every July! Well, no question the touch-off menu in Axis works correctly, but I'm trying to figure out how to do it from within a G-code program. I will have to experiment with it some more next time I have the machine set up.
And, yes, I have a piece of G-code laboriously created with Bobcad/CAM to cut out a pattern of 12 pie-shaped holes for a 3.15" boxer fan. The center of the fan is coord (0,0) and I just set up a coord system for the offset to the center of the fan's location. I did it using Axis' menus, yesterday, to get the job done, but now I WANT to know how to create the relative offset in the G-code file. This is for Aram Kasparov's servo box that I'm building. I prefer to just make boards and let the buyers do all that sheet metal stuff, but sometimes people really want a complete box made and filled with boards. So, I don't make these often, and never two the same. Jon ------------------------------------------------------------------------- Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW! Studies have shown that voting for your favorite open source project, along with a healthy diet, reduces your potential for chronic lameness and boredom. Vote Now at http://www.sourceforge.net/community/cca08 _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
