adaptive feed slows down till the velocity does not overshoot the removal rate that aint edm, thats following the slow truck in the slow lane
reversal aint what edm is about unless things are near fatally bad. the normal motion in edm is a jiggly motion that on-the-average moves towards a destination. its jiggly because the correct position varies constantly, the correct position is forward and backward of the present position on a micro or miliisecond basis. path reversal is in seconds not fractions. path reversal is what you do when things are WRONG path reversal is not how you move to the correct position. path reversal is like air bags in a car, so path reversal is not about good motion control its fire prevention, no its the fire department. it's way after the control system failed. tomp On 02/26/2016 05:56 PM, andy pugh wrote: > On 26 February 2016 at 07:34, Nicklas Karlsson > <[email protected]> wrote: >> Anybody familiar with EDM who could tell me how to adjust the feed rate for >> EDM operations? > There is a motion.adaptive-feed pin that can control the feed-rate > according to an input to HAL. You would use this. > > You might want to look at the experimental reverse-run branch, which > allows negative values in the adaptive feed and in that case runs > backwards through the G-code. > ------------------------------------------------------------------------------ Site24x7 APM Insight: Get Deep Visibility into Application Performance APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month Monitor end-to-end web transactions and take corrective actions now Troubleshoot faster and improve end-user experience. Signup Now! http://pubads.g.doubleclick.net/gampad/clk?id=272487151&iu=/4140 _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
