Hi, Could there be just an error message "Error: Tool Number" If current-tool does not match tool no from last M6 Tx?
-- Tero Kaarlela Production Engineer Eka-Sorvaus OY Nivala Finland ----Alkuperäinen viesti---- Lähettäjä : [email protected] Pvm : 20/10/2016 - 18:39 (EEST) Vastaanottaja : [email protected], [email protected] Aihe : Re: [Emc-developers] Start from line no On 20 October 2016 at 15:54, [email protected] <[email protected]> wrote: > Might this be a bug? If I try to restart a program with tool changes from > certain line. Machine goes to tool change position and goes thru(changes) all > tools prior the tool needed for that line and after that starts running > program from line wanted. I am running 2.8 and machine has ATC. GUI is > gmoccapy. That's probably better than the alternative of running from line with whatever tool happens to be in the spindle. But I don't think that it has always done that. This might be a Gmoccapy thing. I have the impression that there are quite a few features built-in to Gmoccapy that probably really belong in the base software. -- atp "A motorcycle is a bicycle with a pandemonium attachment and is designed for the especial use of mechanical geniuses, daredevils and lunatics." — George Fitch, Atlanta Constitution Newspaper, 1916 ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
