On Tuesday 14 April 2020 06:07:31 andy pugh wrote: > On Tue, 14 Apr 2020 at 10:33, Gene Heskett <[email protected]> wrote: > > How, since even the newer, bad code runs thru runtests w/o any > > problems,
> Bisect does not care how you test. But it is probably easiest to run > it on the machine that is showing the problem. I am. The rest of my machines are running just fine although I have not not yet built master on the pi yet which I usually do over the weekends. > > > Can someone suggest a starting branch that ideally would start the > > bisect say at 2 weeks prior to the beginning of the 2.8 merge, just > > to verify it did work then? > > 2.8 merges in to master rather regularly, but 2 weeks ago would be > 7bfebcb23a643c084fc39f1d3bfca9a29c64ae6c > (just from browsing > https://github.com/LinuxCNC/linuxcnc/commits/master) > > git checkout 7bfebcb23a643c084fc39f1d3bfca9a29c64ae6c > Will take you back in time 2 weeks. which may be not enough but its building now. Keep in mind I have to make debs and install them and reboot to try them as the shutdown is not cleaning house as I quit it and I have to reboot to get a clean slate for the next try. That didn't happen when it was working correctly. This same machine is one of 2 that are running on a 240 GB SSD, an older dell with only 1 sata port. Much faster at about 150MB/sec read speeds. Got the rpi4b build underway. Ain't ssh wunnerful... :) 2 weeks apparently wasn't enough, its broken there. How do I back the bisect start "good" up another 2 weeks? That surely should get it in good shape. In the meantime I have to go drop the card for a new mower. Back later. Thanks Andy. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
