On Tuesday 14 April 2020 19:29:26 Gene Heskett wrote: > On Tuesday 14 April 2020 18:27:20 andy pugh wrote: > > On Tue, 14 Apr 2020 at 22:54, Gene Heskett <[email protected]> > > wrote: > > > > What's that # doing there? > > > > > > IIRC, removeing a later duplicate link. > > > > I don't see any duplication. Have you tried removing it? > > did just now, no diff. It still runs away slowly, a .005 offset, but > outputs no steps except then the up-down key is being pushed. When one > of them has been pushed and then released the stepgen output is turned > off, so the axis is not moving, but the dro marches along slowly as > does the fb number out of the stepgen until around an inch later it > finally trip off with a following error. Sometimes the direction of > the phantom drift is reversed by the opposite key and sometimes the > dro continues marching along in the same direction until it finally > throws a following error, but usually moves the dro an inch or better, > all of this w/o a physical axis movement unless a key is actually > pushed. > I seem to have fixed it. I went up the file to the x axis section and duplicated a couple dozen lines, changing only the axis/joint references, then went down and deleted that same duplicate stanza which was now a repeat and surplus. No clue what I did other than reorder the file, but it now works. Go figure.
I did find out one thing though, that I could bring the y table fwd far enough to drop off the far side of the home switch. It won't home from there as it runs the wrong way looking for the switch, ending that move with an error 7. Now maybe if it quits raining, I can do something about my jungle later today. g'night all. > Cheers, Gene Heskett Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
