Greetings, On Mittwoch, 15. April 2020, 15:00:38 CEST Stuart Stevenson wrote: > It sounds to me like you will run into a problem with G41/G42 ... > When using G41/G42, if the tool radius (plus any diameter/radius > modification for roughing) is not smaller than the programmed radius of the > corner LinuxCNC will give you an error code and will not run.
Well, that is correct and expected behaviour. Of cause, if faking tool properties, linuxcnc should use the resulting properties to (re-)calculate the new toolpath. If that would not be the case, the support for faking tool properties would be useless. But tests with G43.1 gimme the hope, that linuxcnc already takes the fake values for path calculations. I will test that, when I have a new dev-box up and running. Reinhard _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
