Den 2022-09-18 kl. 21:20, skrev Jérémie Tarot:
Le jeu. 15 sept. 2022 à 12:25, Nicklas SB Karlsson <n...@nksb.eu> a écrit :.
Is there any good reason surface speed should start at maximum until
tool is moved? Or would it be better tool does not have be moved before
surface speed is active?
What's the X position of the tool after tool change and the active
work/rapid mode?
Shouldn't G96 be enabled only just before lead in move?
Maybe on lathe.
Use it on a mill. If diameter of drill is changed rpm will change so
that surface speed is the same and guess feed normally make very little
or negligible difference. Tables I have surface speed is the same for
different diameters so it make sense even though not very important
though with well written g-code program it is possible to change
diameter of a tool and part is still correctly machined.
Nicklas Karlson
_______________________________________________
Emc-developers mailing list
Emc-developers@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-developers
