mån 2022-11-14 klockan 00:06 +0000 skrev andy pugh: > Just to clarify: Is this still an issue, or was it a misunderstanding > of CSS mode? > Maybe a little bit of a misunderstanding as it was intended for lathes. Though for mills it make it either work considering the drill diameter instead of the x position or G96 is disabled give an error message if used.
Nicklas Karlsson _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
